Skid mounted cold 10 GPM 3000 PSI pressure washer w/ green spring YU21405s unloader Honda muffler.

       Must inspect and or tighten belts after 30 days. No warranty on belts. Unloader settings, clogged nozzles and loose belts are some causes of belt failure. Must use the 50' of 1/2" ID hose with this unit.

       The PL-8-TA or PL-8-TO kit has everything you need to plumb the pressure washer as well as connect to a reel including the 50' high pressure hose.

       Up-sizing your hoses will prevent back-pressure to your pump, help your valves and high pressure seals last longer, prevent your safety relief valve from spraying water, help your pump run at a cooler temperature, supply enough water to your pump using the 'Double your supply hose ID in relation to your inlet port' rule and keep your pump cooler leading to less down time. 

       Always use medium threadlock on your high pressure fittings instead of Teflon tape. Teflon tape will end up in the pump valves or clog nozzles.

       You need to buy a battery and battery box and add a remote fuel tank. Add fuel and connect to a minimum of 200 gallon water tank or IBC tote.

       Add a high temperature Hudson float valve (Hudson-HT ) and Hudson float valve installation kit (Hudson-A or HB) to prevent over-filling your water tank. 

MUST USE ETHANOL FREE FUEL OR THE ENGINE WARRANTY WILL BE VOIDED.

Standard Features:

• YU21405s unloader
• TSF2221 belt driven pump
• Engine and pump oil drains offer easy maintenance
• 3VX450 banded belt system offers balanced power transfer
• iGX800 Honda: electronic fuel injection provides higher output and performance
• Lower vibration and quieter operation
• All units feature electric start and include marine battery box
• Can not be shipped inside the state of California

Note:

        All units are completely factory assembled, tested in the USA, and delivered ready to operate. Bypass hose will arrive with a small amount of water in hose from testing at the factory.

       We highly recommend adding the best high pressure 3/8" ball valve (6292.SM) to this order to allow you to turn off the flow of water to switch from the gun to a Whisper Wash AQUA PRO. You will need to ask for two nozzles 6.0 25 degrees for a two nozzle spray bar (part 1848 or 1118) or four nozzles 3.0 25 degrees for a four nozzles spray bar (part 1769).

Mounting holes: 11 1/8" x 24"

       As with any pressure washer, do not adjust the unloader. The unloader is set at a spike pressure of 200 PSI above the operating pressure of the pump and meant to be left alone. If you need less pressure, change out the nozzles to a larger orifice and never smaller than what is called for using factory specifications using GPM and pressure. This unit requires a 8.5 orifice or larger nozzle. You can add a 6540-8 JROD kit & the Kyle Davis long range shooter nozzle (SN8I) to this pressure washer to experiment with pressure and distance.

SKU: PW.S1030G