Tips for storage and use:

1. Store sealed and protected from light at room temperature. Avoid heat or sunlight.

2. Recommended temperature: 18-35℃. The printing effect may be affected if the temperature is too low. The resin can be preheated properly (no more than 60℃) before use.

3. If the pigment settles in the resin, mix or shake well before use.

4. In order to ensure the desired properties of the cured materials, it is necessary to control the intensity and time of the light source during subsequent polymerization. Therefore, it is suggested that:

(1) The intensity of the mercury lamp or LED light source is 5-10 MW/m2, and the duration should not exceed 1 hour (self-regulation);

(2) The duration of sun exposure (summer) should be controlled at about 1 hour;

(3) Close or long-term exposure under strong light sources such as high-power high-pressure mercury lamps is prohibited;

(4) It is recommended to print in a dark room or cover when printing.

Tip: *It is not recommended to pour cleaning waste directly into the drain. It is recommended to vaporize or heat the water outdoors, and then use light to harden the residual resin.

For perfect and successful printing, please refer to the User Manual in the "Product Guides and Documents" section of this page for more detailed information.

• ANYCUBIC Resin Recommendation Index（The higher the star, the better the performance）